 |
| OK - dash cluster leaves the dining room and moves to the shop... |
 |
| Installed some long all-thread rods to make the job easier |
 |
| Realized we'd better remove the steering column to make it smoother |
 |
| OK - steering column removed. |
 |
Gauge cluster test-fit. Let's connect all these wires! |
 |
| Hooked up the Tach cable... |
 |
| Reinstalled the connectors through firewall |
 |
| Reinstalled the door closure pins |
 |
| Sanded the speaker grille and prep 'd it for paint |
 |
| Pulled the all-thread rods and put in the correct screws |
 |
| Installed the headlight switch... |
 |
| Installed the passenger vent pull |
 |
| Installed the grab-bar bezel |
 |
| Finished painting the speaker grill. We'll install that tomorrow. |
 |
| Starting sanding the radio side panels. We'll prime & paint those tomorrow. |
 |
| End of Day. It was a Good one! : )) |
No comments:
Post a Comment